% of people told us that this article helped them.

What do I do if the gasket seems to be leaking after cleaning my front load washer? Once the filter is in place, reinstall the hose to the tub opening. Please also refer to the full instructions in our article section about drain and filter checks.

Now, take out all the screws holding the main, rear panel to the washer.

The cover is held in place by four locking tabs, simply disengage the tabs with your screwdriver, and pull the cover off the damaged tub filter. Clean the filter and pump housing under running water and refit the filter.

When the filter is clean, replace it and put the outer cover back.

If you need to add or remove a garment after the cycle has started, press the pause button to temporarily stop the cycle. Turn the dial to choose the right cycle for your laundry load. Before you begin disassembling your washing machine, unplug the appliance and turn off its hot and cold water supply valves.

If you notice excessive vibrations, wet clothes after the final spin, or problems with the water draining, the filter may be clogged and you should check it right away. To learn how to prolong the life of your filter, keep reading! "I wasn't aware that a washing machine has an accessible filter that can be cleaned.".

If you cannot remove the screen from the filter, hold the filter under hot running water until all of the residue is removed. Once a month, clean out that filter to remove lint and old laundry detergent." Delay the start of any cycle from 30 minutes to 12 hours. Keep spraying and wiping until your cloth comes away clean. ", "Cleaning the inside of rubber gasket - great advice, thanks.". © Copyright 2020 Electrolux | Help and Support.

The gasket will remain fixed to the washing machine, but you can pull it open to clean it and make sure nothing is stuck.

Take and twist the plug out and drain. Although they also differ a bit in features and finishes -- some use Wave-Touch controls, while others rely on Electrolux's IQ interface -- these washers are quite similar in terms of construction, right down to the chrome accents. High-efficiency (HE), front load washing machines are easy to love because they require less water and detergent. Pick up the main top panel and place it on the washer, leaving about an inch or two of space between the front of the panel and the front of the washer. If the coin trap is damaged and debris is able to bypass the filter, your washer may not drain properly, or the drain pump may sustain irreparable damage, meaning it will also need to be replaced. By locating and removing your filter, cleaning it, and taking steps to prolong your filter’s life, you can save yourself hundreds of dollars in repairs. Otherwise, hold the filter under hot running water until the residue is gone. Ft. Press the cycles button to select the right cycle for your laundry load. Please help us continue to provide you with our trusted how-to guides and videos for free by whitelisting wikiHow on your ad blocker.

A dirty filter can also cause your washing machine to start smelling. Chris Willatt is the owner and founder of Alpine Maids, a cleaning agency in Denver, Colorado started in 2015. Cold water is recommended for lightly soiled or brightly colored or dark items. Plus, SmartBoost™ technology pre-mixes water, detergent and stain remover to maximize their cleaning power, so there’s no need to pre-treat ahead of time. This article was co-authored by Chris Willatt. Then, push the retainer back into the small opening in the reinstalled rear mounting bracket. The StainSoak option customizes your wash cycle, time, and temperature to eliminate common stains that need specific treatment—chocolate, blood, or any stain. Electrolux recommends using a high-efficiency (HE) detergent for front load washers.

Yes - the seal is manufactured in such a way as to provide a serviceable component. Close the drain hose and put it back in its original place.

Avoid hard, gritty or abrasive cleansers. If you really can’t stand to see another ad again, then please consider supporting our work with a contribution to wikiHow. If pods are used, please place the pod directly into the washer drum BEFORE placing laundry into the unit. Problems with your washing machine can be infuriating, especially when your clothes are soaking wet after the final spin. Next, find your filter, which will either be in the bottom right corner on the outside of the washer, the bottom right-hand corner of the inside of the machine, or underneath the agitator. I have an Electrolux EWF12832. • Add your preferred stain remover to the Pre-Wash chamber of your detergent tray• Select the StainTreat Option• Press set• Press start. It is recommended that you clean the washing machine with a cloth soaked in a mild universal detergent or washing-up liquid, because washing machines are often manufactured from baked-on enamel. I will be sure to wipe the, "The correct amounts for the baking soda and vinegar really helped. Then, slide the tub filter into the tub to pump hose. Thanks to all authors for creating a page that has been read 91,302 times. • Select as many options as you like, pressing set after each selection. A clogged tub filter can also cause an issue with the draining process. Amid the current public health and economic crises, when the world is shifting dramatically and we are all learning and adapting to changes in daily life, people need wikiHow more than ever.

If your washer is vibrating, it may be due to installation issues. If the drain hose blocks the filter from coming out, remove it and then pull out the filter.

After opening the access door or removing the.

Add the recommended amount of a high efficiency liquid detergent to the Main Wash – Liquid Only cup.

If you need to clean your front load washer, start by grabbing the door’s gasket, which is the ring of rubber that goes between the door and washer.

Take the drive belt off the back of the tub, by gently tugging on the belt while rotating the drive pulley. Luckily, checking and cleaning your washing machine filter is a quick and easy process. Next, start unthreading the screws that hold the main top to the washing machine. Then, use a rag to clean the dust and hair out of the gasket. The appliance is now ready to be used again.

We use cookies to make wikiHow great. How can I remove a bad odor from the drum of a front-loading washing machine? Safety should always be a priority when repairing one of your appliances, so please protect your hands and eyes by wearing work gloves and goggles as you replace the tub filter in your washer. Fabric softener will not dispense into washer, what do I do? Block up your machine and you'll have easier access. Open the door to the fluff filter and place the drip tray underneath.

How to Clean Your Electrolux Front Load Washing Machine. This article was co-authored by Chris Willatt.

We know ads can be annoying, but they’re what allow us to make all of wikiHow available for free.